Vaillant Mixer module VR 61 Manual de instalación descargar pdf (Pagina 14)

Operating and installation manual for VR 61 mixer module14

– Display screen A3

Installation assistant

System configuration

Relay output ZP/LP:

> Select



A 3

Fig. 7.2 Installation assistant display screen A2

Note!

If the heating system is structured according to

hydraulic drawing2 or 4, the relay output ZP/LP

must be set to "LP".

– Display screen A5

Installation assistant

Module test

Module selection

> Select

VR 61



A 5

Activation heat generator

OFF

Sensors

Actors HK1-P

VF2

Fig. 7.3 Installation assistant display screen A5

On display screen A5 of the installation assistant you

can select the components for which a function test

should be carried out (the components are actuated

briefly).

It is a pre-requisite that "VR 61" is selected as the

module selection.

Sensors Actuators

VF2 Feed sensor 2 LP/ZP

Charging pump/

circulation pump

HK1-P Pump heating circuit 1

HK2 Mixer valve

HK2-P Pump, heating circuit 2

Table 7.1 Components for function test in display screen A5

Attention!

Improper installation/assembly can lead to

damage to the heating system.

A function test of the components should be

carried out using the installation assistant

within the framework of the start-up.

If you wish to leave the installation assistant:

⇒ Turn the left hand adjuster of the controller

VRC 430 VRC 430f in a clockwise direction to

reach the display screen A6.

⇒ Confirm the termination of the installation with

"Yes".

Note!

If you have confirmed the end of the installation

with "Yes" you can only access the

installation assistant via the code-protected

expert technician level (see

installation instructions VRC 430 or

VRC 430f).

7.2 VRC 430 / VRC 430f Operating

level for the expert technician

The operating level for the expert technician serves to

display and for the setting/modification of

specific operating data. This will match the control

system to the heating system in an optimum manner.

This is advisable if the heating installation has other

components in addition to the heating circuit 1 (HC 1)

(e.g. heating circuit 2, hot water storage tank, ventilation

system, solar system).

The operating level for the expert technician includes

the display screens C1 to C26 and the display screens

A1 to A6 of the previously described installation

assistant.

Depending upon the configuration of the heating system,

the display screens not required are hidden.

The display screens C1 to C26 in the controller

VRT430 or VRC 430f in the same sequence as shown in

the following Table 7.2.

This table shows which parameters can be adjusted and

changed.

The following differences in the displat screens are

produced by the installation of the mixer module

VR 61 in the heating system with respect to the standard

configuration as described in the manual for the

VRC 430 or VRC 430f:

C2, C4, C10, C11, C15, C22, C23 and C26

7 Start-up

For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - [email protected]

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comentarios a estos manuales

Sin comentarios

Vaillant Mixer module VR 61 Manual de instalación Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Termostatos Vaillant Mixer module VR 61