Vaillant Mixer module VR 61 Manual de instalación descargar pdf (Pagina 13)

13Operating and installation manual for VR 61 mixer module

Note!

If a charging pump or circulation pump is

connected, the configuration is carried out

using the installation assistant of the controller

VRC 430 or VRC 430f.

Fig. 6.3 Fitting the feed sensor 1

Key

1 Feed sensor 1 (VR 10)

2 6 pole edge connector X8 for plug socket location in the control

cabinet of the heating equipment

After connecting the electrical installation:

⇒ Secure all the lines in the VR 61 with the included

cable brackets (see Fig. 5.2).

⇒ Insert the casing cover back of the VR 61 into the

hinges and hinge the casing cover

back up into position.

⇒ Screw the casing cover in

position in accordance with Fig. 5.1.

7 Start-up

The commissioning of the mixwe module VR 61 is carried

out in conjunction with the commissioning of the

controller VRC 430 or VRC 430f.

Proceed in accordance with the instructions in the

manual of the VRS 430 or VRC 430f controller.

7.1 Installation assistant

When commissioning for the first time, you will be

supported by the installation assistant.

With the installation assistant you can enter the most

important parameters of the heating system.

The following differences are produced by the

installation of the mixer module VR 61 in the heating

system with respect to the standard configuration as

described in the manual for the VRC 430 or VRC 430f:

– Display screen A2

Installation assistant

System configuration

Mixer mode HC1

> Select

Cylinder

active



A 2

Mixer mode HC2

Base display (G1)

HC1

Fig. 7.1 Installation assistant display screen A2

The configuration of the heating system is shown in

display screen A2.

In the heating circuit mode HC1 you can select between

burner circuit (BK) and inactive.

In the heating circuit mode HC2 you can select between

mixer circuit (MK), inactive and Zone.

Note!

If the heating system is structured in

accordance with hydraulic drawing 4, i.e. two

uncontrolled heating circuits, "Zone" must be

selected in heating circuit mode HC2.

In the case of the storage tank you can switch between

active and inactive.

Using the parameter basic display (G1) you can

determine whether the display screen G1 is not shown at

all (value "OFF") or whether the values from heating

circuit 1 or heating circuit 2 are dispalyed.

Electrical installation 6

Start-up 7

For latest prices and delivery to your door visit MyTub Ltd - 0845 303 8383 - www.mytub.co.uk - [email protected]

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comentarios a estos manuales

Sin comentarios

Vaillant Mixer module VR 61 Manual de instalación Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Termostatos Vaillant Mixer module VR 61