Vaillant geoTHERM SERIES Manual de instalación descargar pdf (Pagina 60)

Installation instructions geoTHERM VWS/VWW 0020057444_0160

Display shown Description Factory setting

diagnosis

CH circuit

Buffer VF1 45 °C

Buffer RF1 36 °C

Sensor VF2 38 °C

Current DHW temp. 52 °C

<UV1> HK

Buffer VF1: Buffer cylinder top temperature sensor

Buffer RF1: Buffer cylinder base temperature sensor

Sensor VF2: Current CH flow temperature

Hot water SP: Temperature in the domestic hot

water cylinder.

UV1: = Status of 3-way valve (HK = heating circuit,

WW = hot water)

Menu I: Display general information In Menus I1 to I4 you can obtain information regard-

ing the settings for the heat pump.

Error History

Fault number >1

Fault code 96

16.02.08 07:18

Error

Error - sensor fault

Display of the error memory, showing the last 10 er-

rors in the order they appeared.

The error number with error code, the date/time of

the occurrence and a short description of the error

can all be read. The error number shows the order in

which the errors occurred. The error code identifies

the error. You will find a listing in Chap. 10.

Turning the

dial shows the next error.

—

Statistics

Compressor hours 7 hours

Compressor starts 33

Aux. heating hours 2 hours

Aux. heating starts 21

Compressor hours: Compressor operating hours to

date.

Compressor starts: Number of compressor starts.

Aux. heating hours: Auxiliary heating operating

hours to date.

Aux. heating starts: Number of auxiliary heating

starts.

—

Software releases

I/O card 1 3.34

User Interface 1 2.22

VR 80

VR 90

Software release I/O card (PCB in the heat pump).

Software release of the User Interface (display in

the operating console).

VR 80: displays the software release when a VR 80

is connected.

VR 90: displays the software release when a VR 90

is connected.

—

Reset? No

Code 1: 0000 Code 2: FFFF

Codes accepted ? No

Reset: Reset of fault-induced shutdowns; all running

processes are immediately interrupted; the heat

pump starts up again.

Code 1/Code 2: No function! Values must not be

changed!

0000; FFFF

Table 8.4 Parameters that can be set in the Code level (cont.)

see Figs. 1 and 2 in the appendix

8 Controller

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Comentarios a estos manuales

Sin comentarios

Vaillant geoTHERM SERIES Manual de instalación Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Vaillant geoTHERM SERIES